Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Dynamic Configuration and DTS Shutdown/Restart

DTS Restart

Chapter 4

DTS Restart

The DTS restart capability is provided by the DTCCNTRL command and allows you to

restart the DTS subsystem.

NOTE The DTS must first be shut down before it can be restarted.

Performing a DTS Restart

To perform a DTS restart, type the DTCCNTRL command at the CI prompt either without

specifying the desired restart operation or by specifying it using the syntax outlined

below:

• DTS restart operation not specified:

• DTS restart operation specified:

:DTCCNTRL func=restart

NOTE To dynamically configure DTS changes, refer to the “Dynamic Configuration” section

earlier in this chapter. To automatically add/configure a host-based managed DTC to

DTS without needing to specify detailed configuration information such as DTC

cards/boards and ldevs, refer to Chapter 3, “Automatic Configuration of DTCs.” To

manage/dynamically configure host-based X.25 links, refer to the Configuring and

Managing Host-Based X.25 Links manual.

:DTCCNTRL

0 exit

1 dynamically implement DTS changes made in NMMGR

2 view status of last DTS dynamic configuration

3 automatically add a new DTC

4 shutdown DTS subsystem

5 restart DTS subsystem

6 manage/dynamically configure host-based x.25

7 help

For help on these topics, select 7 at the prompt below.

Select one of the numbers above corresponding to the desired

operation: 5