Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)
Dynamic Configuration and DTS Shutdown/Restart
Performing a Dynamic Configuration
Chapter 4
60
Or you can run NMMGR again and select validate DTS/Link. See the section
“DTCCNTRL After NMMGR Exit,” for steps on how to invoke the DTCCNTRL command
at the CI prompt.
If you type H, you will see help text describing the options.
NOTE You can suppress the display of the question and have DTS changes become active
dynamically, without prompting, by using capabilities within NMSTART as
discussed later in this chapter.
3. If you selected Y in step 2 above and the DTS changes you have made are
dynamically configurable, no other action is required and changes will become active
automatically. You will see a message on the screen indicating that no other actions
are required.
If the DTS changes you have made require additional actions before changes become
active, refer to Chapters 5 and 6, step 9, for more information. If this is the case, you
will see messages on the screen indicating what actions are required before changes
become active.
Refer to Table 4-1 for a list of configuration changes that can be modified
dynamically.
4. After viewing the messages describing what actions are required, if any, enter
[RETURN]
when you see the prompt:
(Press RETURN when finished viewing screen contents.)
You will return to the Validation screen. From here you can make further changes or
exit NMMGR.
DTCCNTRL After NMMGR Exit
If you choose not to invoke DTCCNTRL implicitly within NMMGR, you can run the
command from the CI prompt at any time after you exit NMMGR. DTCCNTRL requires
that you have a minimum of Network Manager (NM) capability.
The command can be entered either without specifying the desired dynamic
configuration operation or by specifying it using the syntax outlined below:
• Dynamic configuration operation not specified:
:DTCCNTRL
0 exit
1 dynamically implement DTS changes made in NMMGR
2 view status of last DTS dynamic configuration
3 automatically add a new DTC
4 shutdown DTS subsystem
5 restart DTS subsystem
6 manage/dynamically configure host-based x.25
7 help