Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Dynamic Configuration and DTS Shutdown/Restart

Dynamic Configuration

Chapter 4

– change term type file name/number * For these changes, the device

must not be owned when dynamic

configuration is invoked. The

terminals must be logged off and

the printers must be not spooled.

– change modem type

– change speed/parity

– change hardware handshaking

– change reset HP terminal

– change allow :HELLO logon

– change record width

Delete:

– terminal/printer*

– ldev*

– DTC*

Decrease number of non-nailed TIO/PAD ports*

Change starting ldev of non-nailed ports*

Host-based X.25 configuration changes: Use DTCCNTRL to:

– change PAD access 1) Stop X.25/PADSUP

– change level 1, 2, or 3 configuration 2) Start X.25/PADSUP

(see Configuring and Managing

Host-Based X.25 Links for more

information)

Add/configure new DTC Reboot or reset DTC

Perform automatic configuration

(see character 3 for more

information)

Add/configure a TIO card 1) Logoff any sessions that were

logged on through the changed

DTC

Change DTC IP address 2) Reboot DTC (see Chapters 5/6,

step 9, for more information)

Table 4-1 Dynamically Configurable Tasks (Continued)

Task

Action Required for Change to

Become Active