Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Error Messages
DTCCNTRL Error Messages
Appendix E
241
CTLERR 103 System error: bad status received from io_info_list, err_num = !, proc_num = !.
Cause: Internal error.
Action: Contact your Hewlett-Packard support representative.
CTLERR 104 System error: bad NDM port number returned.
Cause: Internal error.
Action: Contact your Hewlett-Packard support representative.
CTLERR 105 System error : bad Send_msg status received, info = !, subsys = !.
Cause: Internal error.
Action: Contact your Hewlett-Packard support representative.
CTLERR 106 System error: bad Extend_receive status received, info = !, subsys = !.
Cause: Internal error.
Action: Contact your Hewlett-Packard support representative.
CTLERR 107 System error: bad reply received.
Cause: Internal error.
Action: Contact your Hewlett-Packard support representative.
CTLERR 108 System error : bad error number returned by DTCM.
Cause: Internal error.
Action: Contact your Hewlett-Packard support representative.
CTLWARN 01 PAD already stopped.
Cause: A DTCCNTRL command was entered to stop PAD support but PAD support was not
active.
Action: No action required. This message is for information only.
CTLWARN 02 PAD already started.
Cause: A DTCCNTRL command was entered to stop PAD support but PAD support was
already active.
Action: No action required. This message is for information only.
CTLWARN 03 X25 already started.
Cause: A DTCCNTRL command was entered to start X.25 support but X.25 support was
already active.
Action: No action required. This message is for information only.
CTLWARN 04 X25 already stopped.
Cause: A DTCCNTRL command was entered to stop X.25 support but X.25 support was not
active.
Action: No action required. This message is for information only.
FUNC specification is not RC, no configuration will be done.
CTLWARN 05 Cause: A DTCCNTRL command was issued with the RECONF option specified but the
function was not RC.