Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Error Messages
DTCCNTRL Error Messages
Appendix E
239
Cause: An attempt was made to reconfigure global data values for the DTC using the RC
function of DTCCNTRL. A problem occurred with the DTC while the new configuration
values were being downloaded.
Action: Check the DTC. Correct any problems then reenter the DTCCNTRL command
with FUNC=RC to download the reconfigured global data values.
CTLERR 15 Global physical security download failed.
Cause: An attempt was made to reconfigure the PAD access password for the DTC using
the RC function of DTCCNTRL. A problem occurred with the DTC while the new
configuration values were being downloaded.
Action: Check the DTC. Correct any problems then reenter the DTCCNTRL command
with FUNC=RC to download the reconfigured PAD access password.
CTLERR 16 SYS-TO-SYS switching download failed.
Cause: An attempt was made to reconfigure the system-to-system switching information
(X.25 link name or number of switched virtual circuits) for the DTC using the RC
function of DTCCNTRL. A problem occurred with the DTC while the new configuration
values were being downloaded.
Action: Check the DTC. Correct any problems then reenter the DTCCNTRL command
with FUNC=RC to download the reconfigured system-to-system switching information.
CTLERR 17 LUG download failed.
Cause: An attempt was made to reconfigure local user group (LUG) information (remote
X.25 address or security level) for the DTC using the RC function of DTCCNTRL. A problem
occurred with the DTC while the new configuration values were being downloaded.
Action: Check the DTC. Correct any problems then reenter the DTCCNTRL command
with FUNC=RC to download the reconfigured local user group information.
CTLERR 18 Start X25 first.
Cause: An attempt was made to start PAD support or to download card-specific X.25
configuration values but X.25 support is not active.
Action: Start X.25 support using the STARTX25 function of DTCCNTRL then retry the
operation. (To start both X.25 and PAD support, use the STARTBOTH function.)
CTLERR 19 X25 download failed.
Cause: An attempt was made to start X.25 support. A problem occurred with the DTC
while the X.25 support values were being downloaded.
Action: Check the DTC. Correct any problems then re-download. Reenter the command
to start X.25 support.
CTLERR 20 The specified card is not an X.25 card.
Cause: The card specified in the DTCCNTRL command is not an X.25 iX Network Access
car.
Action: Obtain the correct card number for the X.25 iX Network Access card and
reenter the command using the correct card number specification.
CTLERR 21 Invalid RECONF specification. Must be All, X25, Card, Pass, or Logcl.
Cause: A DTCCNTRL command was entered using the RC function but an invalid option
was specified in the RECONF parameter.