Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Error Messages
DCC Error Messages
Appendix E
234
Cause: While automatically adding a new DTC no boot request was received within the
allowed time. The DTC is either powered off or the LAN address specified is not correct.
Action: Make sure the DTC is powered on and the correct LAN address is specified.
(DCCWARN 48) DCC WARNING P-L, (LLIO status SSSSSSSS)
Cause: An internal problem has occurred with low-level I/O.
Action: This is a warning. If it persists contact your Hewlett-Packard support
representative.
(DCCWARN 49) DCC WARNING P-L, Ldev LLL is unusable until next DTS restart.
Cause: The ldev was being accessed programmatically when a DTS Shutdown was
performed and the forced=y option was specified.
Action: Logoff the session or job that was accessing the device and restart DTS. Perform
another DTS shutdown and restart.
(DCCWARN 50) DCC WARNING P-L, Waiting 30 sec for ldevs to become free.
Cause: One or more ldevs were in use when DTS shutdown with the forced=y option
specified. DCC is waiting for the reset and/or STOPSPOOL to complete.
Action: No action needed. DCC will proceed automatically.
(DCCWARN 51) DCC WARNING P-L, Dynamic configuration is disabled.
Cause: DCC could not find the Dynamic ID in the config file.
Action: Perform a DTS shutdown and restart. If the warning persists, contact your
Hewlett-Packard support representative.
(DCCWARN 52) DCC WARNING P-L, NMCONFIG is previous version. Run NMMGRVER.
Cause: You have installed DTC patches that contain the new Host-Based DTC
functionality. DCC has determined that the version of the DTS tree in the NMCONFIG
file is still the previous one.
Action: The DTS subsystem will startup normally, but you must run NMMGRVER to
update the version of the NMCONFIG file in order to make configuration changes to the
DTS configuration.
(DCCERR 53) DCC ERROR P-L, NMCONFIG version mismatch. Can’t start DCC.
Cause: DCC has determined that the version of the DTS tree in the NMCONFIG files is
not the version supported on the Release of the OS currently installed. DCC could not
configure the DTS subsystem.
Action: You must run NMMGRVER to update the version of the DTS tree to the current
version. If this fails, you must use NMMGR to create a new NMCONFIG file and rebuild
the DTS configuration. Or restore a backup of your configuration that has the correct
version configured.
(DCCWARN 100) WARNING: I/O config from last START NORECOVERY will be used.
Cause: A routine message; this indicates that a start recovery is being attempted.
Action: No action is required.
(DCCWARN 101) DCC WARNING P-L, (Startup) can not open NMCONFIG, status SSSSSSSS.
Cause: Cannot open the NMCONFIG.PUB.SYS file.