Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Additional DTC Configuration
Configuring SNMP
Chapter 8
151
1. Enter the IP address of the SNMP manager in the “IP Address” field.
The IP address can be any valid individual IP address, or enter *.*.*.* or @.@.@.@
to indicate that any IP address is allowed access.
2. Enter the name of the SNMP community to which the DTC belongs in the
“Community Name” field.
The community name is a maximum of 80 alphanumeric characters and is
case-sensitive.
3. The “Read Only” field defines the access mode to MIB objects. Enter a Y to restrict
the SNMP manager to read-only access; enter an N if MIB objects can be modified by
the SNMP manager.
If two or more managers are configured with the same community name, the “Read
Only” field must be the same for each manager.
4. The “MIB View” field defines which SNMP parameters can be accessed by the
SNMP manager. Enter 1 for DTC MIB or 2 for MIB-II.
If two or more managers are configured with the same community name, the “MIB
View” field must be the same for each manager.
5. After you have configured the authorization filters, press the
[Save Data]
function
key.
Note: Partially-configured filters are not acceptable.
6. Press the
[Go To MIB]
key to configure SNMP MIB parameters or the
[Go To Trap]
key
to configure trap destinations. If you have completed configuration of MIB
parameters and trap destinations, press the
[Prior Screen]
key to return to the DTC
Configuration screen, or press
[Validate DTS/LINK]
to validate your configuration if
you have completed configuration for your DTCs.
Configuring SNMP MIB Parameters
To configure SNMP MIB parameters and enable/disable authentication traps, access the
SNMP MIB Configuration screen. This screen can be accessed by pressing the
[Go To
MIB]
key at the SNMP Authorization Filter Configuration screen or the SNMP Trap
Destination Configuration screen.