Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Additional DTC Configuration
Configuring SNMP
Chapter 8
150
Configuring SNMP
This section describes how to configure a host-managed DTC to act as an SNMP (Simple
Network Management Protocol) agent. For PC-based DTC management, refer to the
Using HP OpenView DTC Manager manual.
Configuring SNMP Authorization Filters
To configure SNMP authorization filters, access the SNMP Authorization Filter
Configuration screen within NMMGR. This screen can be accessed by pressing
[F4]
, the
[Config SNMP]
function key at the DTC Configuration screen. See the beginning of this
chapter to find out how to access the
[Config SNMP]
function key. (Refer to Figure 5-5 for
an example of a DTC Configuration screen for a D TC72MX.) The screen can also be
accessed by pressing the
[Go To Filter]
key at the SNMP MIB Configuration screen or the
SNMP Trap Destination Configuration screen.
The SNMP Authorization Filter Configuration screen for host-based management is
shown below, in Figure 8-4. You can configure authorization filters for up to five SNMP
managers.
Figure 8-4 SNMP Authorization Filter Screen
The “DTC Name” field is a read-only field which indicates the SNMP configuration is for
that specific DTC.