Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

90 Chapter5
Configuring Serial Devices (for Host-Based Management)
Modify the Network Management Configuration File
Step 9: Ensure DTS Changes Become Active
If you answered Y to the question “Do you want DTS changes to
become active now (Y/N)?” in step 8, refer to Table 4-1 in Chapter
4, “Dynamic Configuration and DTS Shutdown/Restart,” for a list of
configuration tasks and associated actions for changes to become active.
For those tasks indicating “No action; changes take effect dynamically,”
no additional actions are required for the DTS changes to become
active. You will see a message on the screen indicating that no other
actions are required. For other tasks requiring additional actions for
changes to become active, you will see messages on the screen
indicating what actions must be taken first..
NOTE If you answered N to the question in step 8, thus choosing not to call
DTCCNTRL, refer to Chapter 4, “Dynamic Configuration and DTS
Shutdown/Restart,” for details on how to invoke DTCCNTRL outside
NMMGR.
Performing a DTC Reboot
First, logoff any sessions. To reset the DTC, turn off the power and then
turn on the power again for the DTC.
You may also use TermDSM, an online diagnostic program for
host-managed DTCs, to reset the DTC. Refer to Troubleshooting
Terminal, Printer, and Serial Device Connections for more information.
Performing a DTS Shutdown/Restart
To perform a DTS shutdown and restart, use the DTCCNTRL command.
Refer to Chapter 4, “Dynamic Configuration and DTS
Shutdown/Restart,” for more information on how to use this command
to perform a DTS shutdown/restart.