Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 3 53
Automatic Configuration of DTCs
Performing an Automatic Configuration Inside NMMGR
Step 3: Complete Automatic configuration
The DTC Automatic Configuration Screen appears (Figure 3-2).
Figure 3-2 The DTC Automatic Configuration Screen
Follow the steps listed here.
1. Make sure that the power for the DTC that you want to
automatically add and configure is turned on.
2. Enter the LAN address of the DTC to be configured in the “DTC LAN
station address” field. The LAN address can be found on a label
inside the front cover or on the back panel of the actual DTC box.
Note that the LAN address is different from the IP address which is
discussed in step 4 below.
3. (Optional) Enter the DTC node name in the format
node.domain.organization in the “DTC node name” field. If you
leave this field blank, a default DTC node name will be created. The
default node name created will be
DTCxxxx.domain.organization, where xxxx are the last four
digits of the DTC’s LAN address and domain.organization are
taken from the host's node name.
4. (Optional) Enter the DTC IP address in the “DTC IP Address”
field. The IP address is used if your HP 3000 is configured as part of
a network and you want the DTC to be able to respond to PING/iX
requests.