Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

52 Chapter3
Automatic Configuration of DTCs
Performing an Automatic Configuration Inside NMMGR
Step 2: Activate Automatic Configuration Process
The DTC Configuration Selection Screen (Figure 3-1) is displayed when
you press the
[Go to DTC] key at the Host Configuration Screen. Here
you can access the DTC Automatic Configuration Screen and activate
the automatic configuration process.
Figure 3-1 DTC Configuration Selection Screen
Follow the steps listed here to enter data for this screen.
1. In the “Automatically add/configure a new DTC (Y/N)?”
field, enter a Y and press the
[Enter] key.
2. The DTC Automatic Configuration Screen will appear.