Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)
Appendix D 221
Error Messages
Validation Error Messages
Path: NMMGRpath — LINK.linkname is not defined. (DTSERR=8)
(DTSERR 8) Cause: The linkname specified on the DTS Configuration screen is not
defined; therefore, the link data record was not created.
Action: Verify the linkname on the Host Configuration screen. If the
link data record does not exist, update the DTS Configuration screen.
Path: NMMGRpath — DTS.PROFPC.profilename is not defined.
(DTSERR=9)
(DTSERR 9) Cause: The profilename on the screen specified by the NMMGRpath is
not defined; therefore, the profile data record does not exist.
Action: Check that the profile name exists on the DTS Profile
Selection screen and, if it does, check that the data record for this
profile was created.
Path: NMMGRpath — The same station address or node name is
being used at DTS.DTC.SELECT.DTCname. (DTSERR=10)
(DTSERR 10) Cause: The station address or node name used on the screen specified
by the NMMGRpath is also used on the screen specified by the path
DTS.DTC.SELECT.DTCname screen.
Action: Go to the screen specified by the NMMGRpath or to the
screen specified by the DTC name and modify the station address or
node name.
Path: NMMGRpath — The same LDEV #nnn is being used at
DTS.DTC.SELECT.DTCname.CARD012. (DTSERR=11)
(DTSERR 11) Cause: The logical device (ldev) number is being used on the screen
specified by the NMMGRpath and on the
DTS.DTC.SELECT.DTCname.CARD012 screen.
Action: Go to one of the two screens and change the ldev number. The
ldev number must be unique for each port.
Path: NMMGRpath — The same LDEV #nnn is being used at
DTS.DTC.SELECT.DTCname.CARD345. (DTSERR=12)
(DTSERR 12) Cause: The same logical device (ldev) number is being used on the
screen specified by the NMMGRpath and on the
DTS.DTC.SELECT.DTCname.CARD345.
Action: Go to one of the two screens and change the ldev number. The
ldev number must be unique for each port.
Path: NMMGRpath — LDEV #nnn is too big (must be <=4679).
(DTSERR=14)
(DTSERR 14) Cause: The logical device (ldev) number is bigger than the allowed
maximum ldev number.
Action: Go to the screen specified by the NMMGRpath and modify the
ldev number.