Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

146 Chapter7
Terminal and Printer Profiles
Host Profile Screen (Host-Based)
If routers are used to connect two DTCs, this field must
contain an IP address.
Line speed The line speed, in bits per second. Supported speeds are
300, 1200, 2400, 4800, 9600, 19200, and 38400. Default
is 9600. (Line speed 38400 is supported for direct
connect devices on DTC 16iX/DTC 16MX and
DTC 72MX only, and the attached device must also
support this speed.)
Modem type Specifies the type of modem used in the connection.
0 means that modems will not be used.
1 means that a US modem will be used.
2 means that a European modem will be used.
3 means that a Five wires modem will be used.
(Supported on DTC 16iX/DTC 16MX and DTC 72MX
only.)
4 means that a US In Out modem will be used.
(Supported on DTC 16iX/DTC 16MX and DTC 72MX
only.)
5 means that a European Modem In Out will be used.
(Supported on DTC 16iX/DTC 16MX and DTC 72MX
only.)
Modem
behavior The DTC supports the following types of modem
behavior which define the protocol used to establish a
modem link between the DTC port and the attached
device. Default is 0.
0 means no modem used.
1 specifies DCE modem behavior. Used for terminal
connections. It uses a 2 minute timer to establish the
link, and the DTC may disconnect if a carriage return is
not received within a 2 minute interval.
2 specifies DTE modem behavior. Used for termtype 26
supported on MPE/iX for remote printer access.
3 specifies DCE modem behavior, except that it does not
use a 2 minute timer to establish the link. The port
remains open for connection establishment and the
DTC does not disconnect the link after a 2 minute
interval. (This option is supported on DTC 16iX/16MX
and DTC 72MX only.)