Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Chapter 3
82
DTC/X.25 Card Configuration -- Nailed PAD Connections
When a X.25 card is configured on a non-managed DTC, NMMGR will display the
screen in Figure 3-10 to allow you to configure nailed PAD devices that will connect
through a shared DTC. The corresponding ports must also be configured on the system
where a DTC with the same DTC node name is configured as a managed DTC. This
screen is available only for a DTC 48, DTC 16, and DTC 72MX.
Figure 3-10 DTC/X.25 Card Configuration -- Nailed PAD Connections
1. Verify that the “DTC name” and “Card number” display are correct.
2. Use the
[TAB]
key to move the cursor to the desired fields. Enter the ldev number,
profile and device name in the fields on the screen for nailed device.
Ldev numbers used for each port on all DTCs must be unique. Up to 4649 terminal
I/O devices may be configured on the HP 3000 Series 900. The largest valid ldev
number is 4679.
The device name entered must match the PAD Device Name entered in the PAD
Access screen on the system where this DTC is a managed DTC. See Step 16:
Configure Nailed PAD Connections.