Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)
Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Chapter 3
63
Step 2: Open the Network Management Configuration File
The Open Configuration/Directory File screen is displayed (Figure 3-1). This screen lets
you specify the configuration and backup file names.
Figure 3-1 Open Configuration/Directory File Screen
Follow the steps listed here to enter data for this screen. Refer to “Fields” subsection on
the next page for detailed information about each field on the screen.
1. NMCONFIG.PUB.SYS is the name required by the software. Verify that this name is
displayed in the Configuration file name field.
2. Verify that the name of the correct backup configuration file is in the Configuration
file name field. The default is NMCBACK.PUB.SYS.
3. Press the
[Open Config]
function key.
4. If the configuration file you are opening does not exist, the following message will
appear on the message line at the top of the screen:
Config file does not exist; press Open Config again to
create it.
Press the
[Open Config]
key again to confirm the creation of the file you specified.
Fields Configuration file name The only valid configuration file name the system
recognizes for use by the network subsystem is NMCONFIG.PUB.SYS.