Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Configuring DTCs Step-by-Step

Copy the Sample File

Chapter 3

Copy the Sample File

Use NMSAMP1.PUB.SYS as a template for first time configuration. This file is supplied

with the MPE/iX operating system. Do not modify NMSAMP1.PUB.SYS. Instead, copy the

sample configuration file into NMCONFIG.PUB.SYS and then modify the file as necessary.

To copy NMSAMP1.PUB.SYS into NMCONFIG.PUB.SYS, enter these commands at the

MPE/iX prompt (:):

HELLO MANAGER.SYS,PUB

FILE CONFIG=NMCONFIG.PUB.SYS;DEV=1

FCOPY FROM=NMSAMP1.PUB.SYS;TO=*CONFIG;NEW

NOTE “DEV=1” must be specified in the FILE equation to specify that the NMCONFIG.PUB.SYS

file is to be stored to system disk 1.