Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
DTCCNTRL Error Messages
Appendix B
212
Action: Reenter the command with a valid RECONF specification. Valid values are ALL,
X25, CARD, PASS, and LOGCL.
CTLERR 22 Invalid specification for FORCED parameter. Must be y or n.
Cause: A DTCCNTRL command was entered using the FORCED option but an invalid value
was specified in the FORCED parameter.
Action: Reenter the command with a valid FORCED specification. Valid values are Y for
“yes” and N for “no”.
CTLERR 23 PAD download failed.
Cause: An attempt was made to start PAD support. A problem occurred with the DTC
while the PAD support values were being downloaded.
Action: Check the DTC. Correct any problems then re-download. Reenter the command
to start PAD support.
CTLERR 24 X25 could not be stopped.
Cause: The DTC failed while X.25 support was being deactivated.
Action: Correct any problems with the DTC or its system connection then reenter the
command to stop X.25 support.
CTLERR 25 PAD could not be stopped.
Cause: The DTC failed while PAD support was being deactivated.
Action: Correct any problems with the DTC or its system connection then reenter the
command to stop PAD support.
CTLERR 26 Start PAD first.
Cause: An attempt was made to download card-specific PAD configuration values but
PAD support is not active.
Action: Start PAD support using the STARTPAD function of DTCCNTRL then retry the
operation.
CTLERR 27 Start X25 and PAD first.
Cause: An attempt was made to download card-specific configuration values but X.25
and PAD support were not active.
Action: Start X.25 and PAD support using the STARTBOTH function of DTCCNTRL then
retry the operation.
CTLERR 100 System error: failed to create a port for DTCPROG, info = !, su b sys=!.
Cause: Internal error.
Action: Contact your Hewlett-Packard support representative.
CTLERR 101 System error: NDM nm_find_port error, err_num = !, proc_num = !.
Cause: Internal error.
Action: Contact your Hewlett-Packard support representative.
CTLERR 102 System error: NDM get_sysbase error, err_num = !, proc_num = !.
Cause: Internal error.
Action: Contact your Hewlett-Packard support representative.