Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
DTCCNTRL Error Messages
Appendix B
209
Cause: More parameters were entered than are defined by the DTCCNTRL command. For
example, the command was entered as:
DTCCNTRL DTC=DTC.ITG.HP;CARD=4;FUNC=RC;FORCED=Y;RECONF=ALL;A=4
Action: Reenter the command without the invalid parameter. For example:
DTCCNTRL DTC=DTC.ITG.HP;CARD=4;FUNC=RC;FORCED=Y;RECONF=ALL
CTLERR 01 Failed to open the catalog file DTCCAT.PUB.SYS.
Cause: The catalog file does not exist or could not be opened at the time the command
was executed.
Action: If the catalog file is missing or has been corrupted, try to restore
DTCCAT.PUB.SYS from the system backup. If this is not successful, contact your
Hewlett-Packard support representative.
CTLERR 02 Operator capability required to issue this command.
Cause: A user without the proper capabilities attempted to issue a DTCCNTRL command.
OP capability is required.
Action: Obtain the required capabilities and reissue the command.
CTLERR 03 Invalid function specified in FUNC.
Cause: The FUNC parameter was not a valid DTCCNTRL function.
Action: Reenter the command specifying a valid function in the FUNC parameter. For
example:
DTCCNTRL DTC=DTC.ITG.HP;CARD=4;FUNC=STARTX25
Valid functions are STARTX25, STARTPADSUP, STARTBOTH, RC, STOPX25, STOPPADSUP,
STOPBOTH, and STATUS.
CTLERR 04 System is not Host-Based X.25.
Cause: The DTCCNTRL command was issued on a system that is not configured as a
host-based X.25 system (either the system is PC-based or it is host-based but is not
configured for X.25 connections).
Action: None. If attempting to control X.25 operation on a PC-based system, refer to the
documentation for PC-based networks.
CTLERR 05 Missing parameter: CARD not specified.
Cause: The DTCCNTRL command was issued with a FUNC parameter that requires a card
number, but no CARD parameter was specified. The STARTX25, STARTPADSUP, STARTBOTH,
RC, STOPX25, STOPPADSUP, and STOPBOTH functions all require the CARD parameter. CARD
is optional only for the STATUS function.
Action: Reissue the command with the correct card number specified in the CARD
parameter.
CTLERR 06 This DTC doesn’t contain X25 cards.
Cause: A DTCCNTRL command was issued specifying the DTC name of a DTC that does
not contain any X.25 iX Network Access cards.
Action: Obtain the correct DTC name for the DTC containing the X.25 iX Network
Access card and reenter the command using the correct DTC specification.
CTLERR 07 DTC not accessible. Use FORCED option.