Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
DCC Error Messages
Appendix B
204
(DCCERR 28) DCC ERROR P-L, Invalid DTC type specified, (DCC status SSSSSSSS.
Cause: The NMCONFIG.PUB.SYS file may be corrupt.
Action: Use a backup configuration file, verify and update your configuration, validate
and cross-validate with SYSGEN, and restart DTS. Keep the corrupt configuration file
and report this condition to your HP representative.
(DCCERR 29) DCC ERROR P-L, DTC is not configured, NM path: NMMGRpath.
Cause: A dynamic configuration change was attempted on a DTC that DCC has not yet
created.
Action: Delete the DTC from the NMCONFIG file and run DTCCNTRL. Then add the
DTC back to the NMCONFIG.PUB.SYS file.
(DCCERR 30) DCC ERROR P-L, Ldev is already configured, (ldev: LLL).
Cause: The ldev #LLL is already configured on the system.
Action: Validate the NMCONFIG.PUB.SYS file and then cross-validate with SYSTEM and
then restart DTS.
(DCCERR 31) DCC ERROR P-L, Duplicate node address or DTC node name. N Mpath: NMMGRpath
Cause: The node address or DTC nodename of a DTC that was added dynamically or
automatically is already configured on an existing DTC.
Action: Verify the node address and nodename of the new DTC and retry the operation.
If the error occurs again, check the configurations of the other DTCs that are in the
NMCONFIG.PUB.SYS file. If the duplicate entry is not found then restart DTS.
(DCCERR 32) DCC ERROR P-L, DTC name is already configured. NM PATH: NMMGRpath
Cause: The DTC name of a DTC that was added dynamically or automatically is already
configured.
Action: Verify that the DTC name doesn't already exist in the NMCONFIG file. If the
DTC name doesn't exist in the NMCONFIG file then restart DTS or pick a different
name for the DTC.
(DCCWARN 33) DCC WARNING P-L, Ldev not added to class. (HLIO status SSSSSSSS, lde vLLL).
Cause: A class contains more than 255 devices, a conflict in class names exists, or
NMCONFIG.PUB.SYS was not cross-validated with files created with SYSGEN.
Action: The ldev is still usable but will not be in the class. Validate the
NMCONFIG.PUB.SYS file and run SYSGEN to verify conflict.
(DCCERR 34) DCC ERROR P-L, Delete Ldev from class failure. (HLIO status SSSSSSSS, ldev LLL).
Cause: The DTC name of a DTC that was added dynamically or automatically is already
configured.
Action: A problem occurred while deleting the ldev from a class.
(DCCWARN 35) DCC WARNING P-L, Ldev not deleted from class. (HLIO status SSSSSSSS, ldev LLL).
Cause: The ldev has already been deleted from the class or the class no longer exists on
the system.
Action: This is a warning. If it persists, make sure no other system utilities are being
used to delete classes or remove devices from classes.
(DCCERR 36) DCC ERROR P-L, Failed to delete ldev LLL. Ldev still in use.