Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
DCC Error Messages
Appendix B
203
Action: Contact your Hewlett-Packard support representative.
(DCCERR 19) DCC ERROR P-L, Link error status SSSSSSSS. LLIO path: NMMGRpath.
Cause: A problem occurred while configuring the link manager.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 20) DCC ERROR P-L, Add LDEV to class failure (HLIO status SSSSSSSS, ldev LLL).
Cause: A class contains more than 255 devices, or a conflict in class names exists, or
NMCONFIG.PUB.SYS was not cross-validated with files created with SYSGEN.
Action: Run SYSGEN to verify the conflict.
(DCCERR 21) DCC WARNING P-L, Configuration file close error SSSSSSSS.
Cause: A problem occurred while closing the NMCONFIG.PUB.SYS file or the
NMCONFIX.PUB.SYS file.
Action: Check that the files exist, and that adequate disk space is available for them. If
the files exist and the disk space is large enough, check for file system or hardware
problems.
(DCCERR 22) NLIO status SSSSSSSS, ldev LLL).
Cause: A problem exists in the NLIO services.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 23) DCC ERROR P-L, Blank NODENAME.
Cause: A host node name was not configured.
Action: Configure a host node name.
(DCCERR 24) DCC ERROR P-L, Configuration file not validated, status SSSSSSSS.
Cause: Either modifications were made to the network management configuration file
and the file was not validated, or the file was validated but the errors listed to the
console were not corrected.
Action: Either validate the network management configuration file, or correct the
errors listed to the console when the file was first validated and then revalidate the file.
(DCCERR 25) DCC ERROR P-L, X.25 Level 1&2 not configured in NMMGR, status SSSSSSSS.
Cause: Level 1&2 of the X.25 network management structure have not been configured
in NMMGR.
Action: Supply the required information in the X.25 Level 1&2 screen in NMMGR.
(DCCERR 26) DCC ERROR P-L, X.25 Level 3 not configured in NMMGR, status SSSSSSSS
Cause: Level 3 of the X.25 network management structure have not been configured in
NMMGR.
Action: Supply the required information in the X.25 Level 3 screen in NMMGR.
(DCCERR 27) DCC ERROR P-L, Invalid card number specified, (DCC status SSSSSSSS, card number
= cardnumber).
Cause: You have specified an invalid card number for the DTC type.
Action: For DTC 72MX, the valid range for card number is 0 to 3. For DTC 48, the valid
range for card number is 0 to 5. For DTC 16, you may use card 0 and 1 for connector
cards and card 2 for X.25 card.