Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
DCC Error Messages
Appendix B
201
DCC Error Messages
As system start-up nears completion, the Datacomm Configurator (DCC) creates the
LINK and DTS managers. If the procedure is successful, the following message will be
displayed on the console:
DCC STARTUP OK!
If the procedure is not successful, the message above is replaced by one or more error
messages.
When looking up an error message, note that the following strings of characters are used
to represent information that is inserted when the message is generated.
• P-L — is replaced by a DCC procedure number and a DCC location number; used for
detailed diagnostics by Hewlett-Packard support representative.
• SSSSSSSS — is replaced by an eight-digit hexadecimal value; also used for detailed
diagnostics.
• MMM and LLL — are replaced by decimal values; used for detailed diagnostics.
• PATH — is replaced by an NMCONF path or LLIO physical path
(DCCERR 1) DCC ERROR P-L, (LLIO status SSSSSSSS).
Cause: A problem exists with the low-level I/O services.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 2) DCC ERROR P-L, (reply status SSSSSSSS, msg descriptors MMM).
Cause: A problem exists with interprocess communication.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 3) DCC ERROR P-L, Configuration file open error SSSSSSSS.
Cause: The configuration file does not exist or it is locked.
Action: Check to see if NMCONFIG.PUB.SYS exists. If it exists, verify that it is the proper
file type and that it is not locked.
(DCCERR 4) DCC ERROR P-L, (NMCONF record error SSSSSSSS). NM Path: NMMGRpath
Cause: The DCC surrogate cannot read a record in NMCONFIG.PUB.SYS, or data in the
file was not validated or the data is corrupt.
Action: Validate the NMCONFIG.PUB.SYS file and restart DTS. If the error persists,
replace the file, validate it, and restart DTS.
(DCCERR 5) DCC ERROR P-L, configuration record data was invalid. NM Path: NMMGRpath
Cause: Data in the NMCONFIG.PUB.SYS file was not validated or the data is corrupt.
Action: Validate the NMCONFIG.PUB.SYS file and restart DTS.
(DCCERR 6) DCC ERROR P-L, (HLIO status SSSSSSSS, ldev LLL).
Cause: A problem exists with the high-level I/O services.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 7) DCC ERROR P-L, (Buffer manager status SSSSSSSS).