Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
Validation Error Messages
Appendix B
197
Cause: You have specified an invalid management timer selection.
Action: Go to the Tune DTC — Timer Selection Screen and choose a value of 1 or 2 for a
management timer selection.
(DTSERR 76) Path: NMMGRpath — Baud rate 38400 for LDEV #nnn, defined in Profile profilename, is
not supported on DTC16 and DTC48.
Cause: You have used a profile that specified a baud rate of 38400 for a device that is
connected to a DTC 16 or DTC 48.
Action: Make sure you specified the right DTC type (not a DTC 16 or DTC 48), or do not
use this profile for the port with LDEV #
nnn
.
(DTSERR 77) Internal error. Failed to get memory.
Cause: The operating system was unable to allocate the memory needed to store data
used during validation.
Action: Build a new file from the sample file NMSAMP1.PUB.SYS. Try to validate the file.
If the same error message appears when verifying the new file, contact your
Hewlett-Packard support representative.
(DTSERR 78) Path: NMMGRpath — A HOST profile is currently configured on LDEV #nnn, must use
LDEV # -1.
Cause: A profile of type HOST has been configured on a DTC port and the ldev specified is
not -l.
Action: Ports using HOST profiles are for back-to-back and must have an ldev of -l. Go to
the screen specified in NMMGRpath and change the ldev to -l or use a different profile
that is not of type HOST.
(DTSERR 79) Path: NMMGRpath — X.25 card is not allowed in slot s.
Cause: An X.25 card has been configured in a slot that is not allowed for the DTC type.
Action: Go to the DTC specified in the NMMGRpath and delete the X.25 card from the
slot number s.
(DTSERR 80) Path: NMMGRpath — Too many X.25 cards are configured. Maximum is 3.
(DTSERR=80)
Cause: To many X.25 cards have been configured in the DTC specified in NMMGRpath.
Action: Go to the DTC specified in the NMMGRpath and delete one or more X.25 cards.
(DTSERR 81) Path: NMMGRpath — LAN cardtype is not allowed on DTC16 or DTC48.
Cause: The configuration for the DTC specified in NMMGRpath has a cardtype of “L”
configured. This is not allowed for DTC16 or DTC48.
Action: Go to the DTC Configuration screen specified in NMMGRpath and enter the
correct cardtypes.
(DTSERR 82) Path: NMMGRpath — Too many LAN cards configured. Only one is allowed.
Cause: The configuration for the DTC specified in NMMGRpath has more than one LAN
card specified in the cardtypes.
Action: Go to the DTC Configuration screen specified in NMMGRpath and change the
extra “L” cardtypes to another valid type.
(DTSERR 83) Path: NMMGRpath — Unknown cardtype specified for card c.