Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
Validation Error Messages
Appendix B
196
Cause: A host node name is not specified on the screen specified in the path.
Action: Enter a host node name on the screen specified in the path.
(DTSERR 54) Path: NMMGRpath — The profile for LDEV #nnn, profilename, is not defined.
Cause: An incorrect profile name was used for the logical device (ldev).
Action: Verify the profile name for the logical device in the DTS Profile Selection
screen.
(DTSERR 57) Path: NMMGRpath — Profile profilename specified for non-nailed PAD terminals is of
PRINTER or PADPRINT type.
Cause: A printer or PAD printer profile is specified where only a terminal or pad
terminal profile is allowed.
Action: Change the printer profile to be a terminal profile.
(DTSERR 58) Path: NMMGRpath — The profile for LDEV #nnn, <profilename>, is for a PAD device
type.
Cause: A PAD terminal or PAD printer profile is specified where only a terminal or
printer profile is allowed.
Action: Change the PAD terminal or PAD printer profile to be a terminal or printer
profile.
(DTSERR 71) Path: NMMGRpath — Modem behavior DCE high for LDEV #nnn, defined in Profile
profilename, is not supported on DTC16 and DTC48.
Cause: DCE high modem behavior is not supported for devices on a DTC 16 or DTC 48.
DCE high is being specified for LDEV #
nnn
, which is on a DTC 16 or DTC 48.
Action: Modify the modem behavior to one that is supported for the DTC, or make sure
you have specified the right DTC type (not a DTC 16 or DT C48) for the device with
LDEV #
nnn
.
(DTSERR 72) Path: NMMGRpath — Hardware handshaking for LDEV #nnn, defined in Profile
profilename, is not supported on DTC16 and DTC48.
Cause: Hardware handshaking is not supported for devices on a DTC 16 or DTC 48.
Hardware handshaking is being specified for LDEV #
nnn
, which is on a DTC 16 or
DTC 48.
Action: Make sure you have specified the right DTC type (not a DTC 16 or DT C48), or
if you are configuring ports on a DTC 16 or DTC 48, do not use a profile that specifies
hardware handshaking.
(DTSERR 73) Path: NMMGRpath — Modem behavior is not supported.
Cause: An invalid modem behavior has been specified. Valid modem behavior values
are: 0, 1, 2, or 3. The configuration file may be corrupt.
Action: Modify the modem behavior specified on the Terminal Profile or Printer Profile
screens to a valid value.
(DTSERR 74) Path: NMMGRpath — Invalid AFCP timer selection.
Cause: You have specified an invalid AFCP timer selection.
Action: Go to the Tune DTC — Timer Selection Screen and choose a value from 1 to 6
for an AFCP timer selection.
(DTSERR 75) Path: NMMGRpath — Invalid Management timer selection.