Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
Validation Error Messages
Appendix B
195
(DTSERR 30) Path: NMMGRpath — Modem type not supported.
Cause: The modem type specified on the DTS Terminal Profile screen is not 0, 1, or 2. A
problem occurred while adding the ldev to a device class. This could be caused because
the class is used by a different type of device such as a HPIB printer.
Action: Remove the class name from the profile for the ldev and delete and re- add the
ldev. Cross-validate the NMCONFIG.PUB.SYS file with SYSGEN. Correct any problems
found then restart DTS.
(DTSERR 32) Path: NMMGRpath — Must supply a Physical Path.
Cause: A physical path was not specified in the Physical Path of LANIC field.
Action: Go to the DTS Configuration screen and enter the appropriate physical path.
(DTSWARN 34) Path: NMMGRpath — Duplicate profile class name profilename used.
Cause: The same class name is used in several terminal profiles or the same class name
is used in several printer profiles.
Action: No action is required. Informational message only.
(DTSERR 35) Path: NMMGRpath — Class name duplicated between printer and terminal profiles.
Cause: The same class name is used for both a terminal profile and a printer profile.
Action: Remove the duplicate class name from the terminal profile or the printer
profile.
(DTSERR 36) Path: NMMGRpath — Profile profilename specified for non-nailed terminals is of
PRINTER type.
Cause: A printer profile is specified where only a terminal profile is allowed.
Action: Change the printer profile to be a terminal profile.
(DTSERR 37) Path: NMMGRpath — Profile profilename specified for non-nailed PAD terminals is of
PRINTER type.
Cause: A printer profile is specified where only a terminal profile is allowed.
Action: Change the printer profile to be a terminal profile.
(DTSERR 38) Path: NMMGRpath — PAD device name for LDEV #nnn is being used in DTC <name>
on Card x.
Cause: A PAD name is used more than once on the specified DTC and card number.
Action: Remove all of the duplicate references to the PAD name.
(DTSERR 44) Path: NMMGRpath — The same PAD LDEV #nnn is being used in DTC <name> on Card
x.
Cause: The same logical device (ldev) number is configured on the PAD card screen
specified by the NMMGRpath and on the specified DTC and card number.
Action: Remove the duplicate ldev number.
(DTSERR 52) Path: NMMGRpath — The same node name is being used at linkname.
Cause: The same node name is used more than once.
Action: Remove the duplicate reference to the node name.
(DTSERR 53) Path: NMMGRpath — Blank NODENAME.