Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
Validation Error Messages
Appendix B
193
Action: Verify the linkname on the Host Configuration screen. If the link data record
does not exist, update the DTS Configuration screen.
(DTSERR 9) Path: NMMGRpath — The non-nailed device profile <name> is not defined.
Cause: The profilename on the screen specified by the NMMGRpath is not defined;
therefore, the profile data record does not exist.
Action: Check that the profile name exists on the DTS Profile Selection screen and, if it
does, check that the data record for this profile was created.
(DTSERR 10) Path: NMMGRpath — The same station address or node name is being used for DTC
<name>.
Cause: The station address or node name used on the screen specified by the
NMMGRpath is also used on the screen specified by the path DTS.DTC.SELECT.DTCname
screen.
Action: Go to the screen specified by the NMMGRpath or to the screen specified by the
DTC name and modify the station address or node name.
(DTSERR 11) Path: NMMGRpath — The same LDEV #nnn is being used at DTC<name> in card 0, 1,
or 2.
Cause: The logical device (ldev) number is being used on the screen specified by the
NMMGRpath and on the specified DTC and one of the three cards.
Action: Go to one of the two screens and change the ldev number. The ldev number
must be unique for each port.
(DTSERR 12) Path: NMMGRpath — The same LDEV #nnn is being used at DTC <name> in card 3, 4,
or 5.
Cause: The same logical device (ldev) number is being used on the screen specified by
the NMMGRpath and on the specified DTC and one of the three cards.
Action: Go to one of the two screens and change the ldev number. The ldev number
must be unique for each port.
(DTSERR 14) Path: NMMGRpath — LDEV #nnn is too big (must be <=4679).
Cause: The logical device (ldev) number is bigger than the allowed maximum ldev
number.
Action: Go to the screen specified by the NMMGRpath and modify the ldev number.
(DTSERR 15) Path: NMMGRpath — Too many LDEVs are being used (must be <=4649).
Cause: Too many logical device (ldev) numbers are being used.
Action: Review the screens that use ldevs and delete some ldev numbers. The
validation procedure allows a total of 4649 ldevs.
(DTSWARN 17) Path: NMMGRpath — Defined LINK.linkname is not being used.
Cause: The defined linkname is not used by DTS or the network interface.
Action: This is a warning only. No action is required.
(DTSERR 18) Path: NMMGRpath — Too many links are being used (max. number allowed = 8).
Cause: The link specified in the NMMGRpath cannot be processed. Too many links are
already defined.