Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
Validation Error Messages
Appendix B
192
Validation Error Messages
The network management configuration file must be validated before automatic
cross-validation with SYSGEN takes place.
The DTS validation procedure starts by displaying the following:
-> Validation of DTS/LINK started. <-
Errors are then listed. When the validation procedure is complete, it will print the
following:
nnn Encountered Errors
-> Validation of DTS/LINK finished. <-
where
nnn
is the total number of errors found during validation.
A numerical list of validation error messages and actions for each follows.
(DTSERR 3) Path: NMMGRpath — A read error encountered while reading the data record (bad file).
Cause: Either a hardware problem occurred or the data record is too long.
Action: Try to print the network management configuration file. Rebuild the file from a
copy of the sample file NMSAMP1.PUB.SYS. If the problem persists, contact your
Hewlett-Packard support representative.
(DTSERR 4) Path: NMMGRpath — A write error encountered while updating the data record (bad
file).
Cause: Either a hardware problem occurred or the data record file is too small.
Action: If the data record file has been compressed, it is impossible to validate the file.
Go to the UTILITY screen and use the compression utility to make the file larger. Try to
validate the file. If it still fails, build the file from a copy of the sample file
NMSAMP1.PUB.SYS. If the problem persists when verifying the new file, contact your
Hewlett-Packard support representative.
(DTSERR 5) Path: NMMGRpath — The data record is empty (use Update Data function key).
Cause: The data record was not created for the NMMGRpath.
Action: Go back to the screen specified by the NMMGRpath and update the screen.
(DTSWARN 6) Path: NMMGRpath — The same physical path is being used at LINK.linkname.
Action: This a warning only. No action is required.
(DTSERR 7) Path: NMMGRpath — The same station address is being used at LINK.linkname.
Cause: The IEEE 802.3 station address is already used. Each station address must be
unique.
Action: Go back to the screen specified by the NMMGRpath or go to the screen specified
by the linkname and correct the station address.
(DTSERR 8) Path: NMMGRpath — LINK.linkname is not defined.
Cause: The linkname specified on the DTS Configuration screen is not defined;
therefore, the link data record was not created.