Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Managing Networks with DTCCNTRL
NMCONFIG and NMCONFIX Files
Chapter 7
157
If you type N, dynamic configuration changes will not take effect now. Your changes
will take effect the next time dynamic configuration is invoked, a DTS
shutdown/restart is performed, or the system is rebooted. Dynamic configuration
changes can be implemented later by calling DTCCNTRL from the CI prompt any time
thereafter. Or you can run NMMGR again and select validate DTS/Link. See the
section “DTCCNTRL After NMMGR Exit,” for steps on how to invoke the DTCCNTRL
command at the CI prompt.
If you type H, you will see help text describing the options.
3. If you selected Y in step 2 above and the DTS changes you have made are
dynamically configurable, no other action is required and changes will become active
automatically. You will see a message on the screen indicating that no other actions
are required.
If the DTS changes you have made require additional actions before changes become
active, refer to Chapter 5, “Preparing to Configure X.25 iX System Access,” and
Chapter 6, “Configuring X.25 Links Step-by-Step,” step 9, for more information. If
this is the case, you will see messages on the screen indicating what actions are
required before changes become active.
Refer to Table 7-1 for a list of configuration changes that can be modified
dynamically.
4. After viewing the messages describing what actions are required, if any, enter
[RETURN]
when you see the prompt:
(Press RETURN when finished viewing screen contents.)
You will return to the Validation screen. From here you can make further changes or
exit NMMGR.