Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Managing Networks with DTCCNTRL
Dynamic Configuration
Chapter 7
155
Host-based X.25 configuration changes:
• change PAD access
• change level 1, 2, or 3 configuration
Use DTCCNTRL to:
1. Stop X.25/PADSUP
2. Start X.25/PADSUP
(see Configuring Systems for
Terminals, Printers, and Other
Serial Devices for more
information)
Add/configure new DTC Reboot or reset DTC
or
Perform automatic configuration
Add/configure a TIO carD
Change DTC IP address
Change AFCP/management timers
Change SNMP MIB data
Change SNMP trap destination
1. Logoff any sessions that were
logged on through the changed
DTC
2. Reboot DTC
You may also use TermDSM to
reset the DTC (see
Troubleshooting Terminal,
Printer, and Serial Device
Connections or more
information)
Change from host-based TIO to host-based X.25
Change DTC LAN address
Change DTC name
Change DTC node name
Change from PC-based to host-based or vice
versa
Change NLIO from Y to N in terminal profile
Change initially spooled in printer profile
Change HP 3000 characteristics:
• node name
• link name
•physical path of LANIC
Add X.25 card to DTC when none previously
existed
1. Use DTCCNTRL to
shutdown/restart DTS
2. Reboot DTC
You may also use TermDSM to
reset the DTC (see
Troubleshooting Terminal,
Printer, and Serial Device
Connections for more
information)
Table 7-1 Dynamically Configurable Tasks (Continued)
Task
Action Required for Change to
Become Active