Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Configuring X.25 Links Step-by-Step
Modify the Network Management Configuration File
Chapter 6
132
Modify the Network Management Configuration File
The procedures that follow describe how to modify the NMMGR configuration file and
network directory file for X.25 iX System Access configuration. These procedures assume
that you have already configured the datacommunications and terminal subsystem
(DTS) for this system. See Chapter 3, “Configuring DTCs Step-by-Step,” for information
on DTS configuration.
Step 1: Begin the Configuration Process
Run the NMMGR program. Node manager (NM) or network administrator (NA)
capabilities are required to run this program. To run NMMGR:
1. Type NMMGR.PUB.SYS at the MPE/iX prompt (:).
2. Press
[Return]
.
NOTE You cannot modify the X.25 iX transport and link configurations in
NMCONFIG.PUB.SYS if the Network Services are active. Verify that the Network
Services are not running by issuing the NETCONTROL STATUS command. You must
have NM (Node Manager) capability to issue this command.
If NS is down, you will see the following two messages in response to the NETCONTROL
STATUS command:
TRANSPORT NOT ACTIVE. (NETXPORTWARN
0001) ENCOUNTERED ONE OR MORE WARNINGS
WHILE PROCESSING COMMAND. (CI W ARN4437)