Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Configuring X.25 Links Step-by-Step
Chapter 6
131
6 Configuring X.25 Links Step-by-Step
This chapter provides step-by-step instructions for configuring X.25 iX System Access for
systems using host-based network management. This manual assumes that you are
using the guided configuration capabilities of NMMGR.
Before using NMMGR to configure a link, you should complete the worksheets provided.
See Chapter 5, “Preparing to Configure X.25 iX System Access,” for more information on
planning your configuration and filling out the configuration worksheets.
This chapter includes step-by-step instructions to help you perform the following tasks:
• Configure the X.25 iX System Access link.
• Configure X.25 virtual circuits.
• Configure neighbor gateways, if there are any.
NOTE If you are configuring X.25 iX System Access on a system using PC-based network
management (an OpenView workstation is part of the network), you should use the HP
3000/iX Network Planning and Configuration Guide instead of this manual to configure
the X.25 link.