Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Chapter 3
103
sysgen> PERMYES ON {Automatically reply YES}
sysgen> SY {Go to the SYSFILE subsystem}
** SYSFILE configurator commands **
aauto (aa) aboot (ab) acmsl (ac) asprog (as)
cmsl (cm) dauto (da) dboot (db) dcmsl (dc)
dsprog (ds) lcmsl (lc) rauto (ra) rboot (rb)
rcat (rc) rcmsl (rcm) rdcc (rd) ripl (ri)
rnmlib (rn) rsprog (rs) show (sh)
clear (cl)(c) exit (ex)(e) help (he)(h) hold (ho)
sysfile> RDCC {Set configuration file to NMCONFIG.PUB.SYS}
sysfile> {HO} {Remove braces to HOLD RDCC command}
sysfile> EX {EXit the SYSFILE subsystem
configuration changes are not kept yet!
still want to exit (yes/no)? Automatic yes
sysgen> BA CONFIG {Set BAse group to CONFIG}
sysgen> KE (KEep the changed configuration data)
keeping to group CONFIG.SYS
Purge old configuration (yes/no)? Automatic yes
** configuration files successfully saved **
sysgen> EX {EXit SYSGEN}
Cross-validation with SYSGEN was successful.
Copying validated configuration file to backup file, please wait ***
(Press RETURN when done viewing screen contents)
3. After successful validation and cross-validation, and if the file in use is
NMCONFIG.PUB.SYS, the following prompt will appear:
Do you want DTS changes to become active now (Y/N)?
Y = all changes made take effect now
N = all changes made will take effect up next dynamic
configuration or system reboot
H = help
>
Answer Y if you want to invoke DTCCNTRL and make DTS changes take effect now,
or answer N if you don’t want DTS changes to take effect now. Note any messages
that describe additional actions needed for changes to become active. After you exit
NMMGR you can review any actions needed by viewing the logs at the end of the file
LOGDCC.PUB.SYS.
If you answer N, the DTS changes will take effect the next time DTCCNTRL is
invoked, a DTS shutdown/restart is done, or the system is rebooted.