Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Chapter 3
102
file with the system I/O devices configured through the SYSGEN utility. This will take
place only if the file opened at the start of the NMMGR session is NMCONFIG.PUB.SYS
and validation is successful. Additionally, you must have System Manager (SM)
capability or the cross-validation will not occur. The commands used for SYSGEN
cross-validation are in the file NMGRXVAL.PUB.SYS. If this file does not exist, NMMGR
will create the file for you before cross-validating. You can edit this file as appropriate for
your environment.
Refer to the MPE/iX manual, System Startup, Configuration, and Shutdown Reference
Manual, for information on SYSGEN.
1. To validate the DTS configuration in the configuration file, press the
[Validate DTS/LINK]
key at the Card Configuration screen. You can also reach the
Validate Configuration File screen by typing validate at the command line on top of
any NMMGR screen and pressing
[Enter]
. (Note that the
[Enter]
key is not the
carriage return key.) While at the Validate screen press the
[Validate DTS/LINK]
key to
validate the DTS configuration.
The DTS validation procedure starts by displaying the following on the terminal:
-> Validation of DTS/LINK started. <-
-> Validation of DTS/LINK finished. <-
If errors were encountered in the configuration file, the validation procedure will
print out the total number of errors found. Error messages will also be displayed
explaining the problems found. Refer to Appendix B, “Error Messages” for more
information about these error messages.
2. After validation of the network configuration file is complete, the following will
appear on the screen as the file is cross-validated with the files created with
SYSGEN (warning messages may vary):
NMMGR will now cross-validate the NMCONFIG file with SYSGEN.
SYSGEN version E.00.00 : catalog version E.00.00 FRI, FEB 4, 1994, 3:32 PM
Copyright 1987 Hewlett-Packard Co. All Rights Reserved.
**warning** No NMCONFIG file in the configuration
**warning** NMCONFIG.PUB.SYS is now the NMCONFIG file
** First level command **
io log (lo) misc (mi) spu (sp)
sysfile (sy)
basegroup (ba) keep(ke) permyes (pe) show (sh)
tape (ta)
clear (cl)(c) exit (ex)(e) help (he)(h) oclose (oc)
redo