Communicator e3000 MPE/iX Release 7.5 (Software Release C.75.00) (30216-90336)

Chapter 4
Fibre Channel Device and Adapter Support on HP e 3000 Systems
Configuration Examples for Fibre Channel Adapters and Devices
47
Now we can shutdown the system and come back to the Boot Command Handler Main Menu. From the Main
menu, set the primary path of the system to the long format path of the FC disk, which we had noted down
earlier.
Console Display #5:
---- Main Menu --------------------------------------------------------
Command Description
------- -----------
BOot [PRI|ALT|<path>] Boot from specified path
PAth [PRI|ALT] [<path>] Display or modify a path
SEArch [DIsplay|IPL] [<path>] Search for boot devices
COnfiguration menu Displays or sets boot values
INformation menu Displays hardware information
SERvice menu Displays service commands
DIsplay Redisplay the current menu
HElp [<menu>|<command>] Display help for menu or command
RESET Restart the system
----
Main Menu: Enter command or menu > pa pri 0/8/0/0.8.0.95.0.0.5
Primary boot path: 0/8/0/0.8.0.95.0.0.5
0/08/0/0.8.0.5f.0.0.5(hex)
Main Menu: Enter command or menu >
Follow the usual procedure to do INSTALL from the tape. When the installation is over, the system can be
rebooted with the primary path remaining as above. On booting from the FC disk as LDEV-1, follow the usual
procedure in SYSGEN to modify the configuration for LDEV-1. During this time, the hardware path to be
used to modify LDEV-1 should be the shorter path format and not the longer one. While setting up the
SYSGEN configuration for the above disk as LDEV-1, use 0/8/0/0.95.5 as the hardware path.
io> ap 0 id=pat_ioa_bc
io> ap 0/8 id=pat_pci_bc
io> ap 0/8/0 id=pci_device
io> ap 0/8/0/0 id=A6795A
<< This is the FC Device Adapter Card >>
io> ap 0/8/0/0.95 id=fc_nport
<< This is the FC Device Nport >>
io> md 1 path=0/8/0/0.95.5 id=hpdarray
<< This is the FC Device disk LUN >>