APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Chapter 4 85
APPC Subsystem Configuration
Configuring the APPC Subsystem
Fully Qualified Remote LU Name
Required. The network ID and LU name of the remote
LU with which the local LU will communicate. A fully
qualified LU name is of the form
NetworkID.LUName ,
where
NetworkID and LUName are strings of up to 8
alphanumeric characters, each beginning with a letter.
If the HP 3000 will communicate with an AS/400, the
NetworkID part must match the Local network ID
configured in the Network Attributes Table on the
AS/400, and the
LUName part must match the
LCLLOCNAME in the Device Description for the partner
LU on the AS/400.
Parallel Sessions
Required. Enables or disables parallel sessions
between the specified local and remote LUs. Enter Y or
N. The partner LU on the remote system must be
similarly configured for parallel or single sessions.
Y The local LU can participate in
multiple, simultaneous sessions with
the remote LU. If you specify Y, the
Maximum Number of Sessions field
will be set automatically to 8. You can
change the default simply by typing a
different value into the field. If the
HP 3000 will communicate with an
AS/400, the SNGSSN value configured in
the Device Description on the AS/400
must be *NO.
N The local LU may participate in only
one session at a time with the remote
LU. If you specify N, the Maximum
Number of Sessions field will be set
automatically to 1. You can change the
default simply by typing a different
value into the field. If the HP 3000 will
communicate with an AS/400, the
SNGSSN value configured in the Device
Description on the AS/400 must be
*YES.
Default: Y (parallel sessions enabled)
Maximum Number of Sessions
Required. The maximum number of APPC sessions
that may be simultaneously active between the
specified local and remote LUs.