APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Appendix A 163
Messages
Error Messages
ACTION: Run NMMGR and validate the APPC subsystem. Note and
correct any errors. If the problem persists, contact your
HP representative.
1035 MESSAGE: UNABLE TO OPEN NMCONFIG FILE. (APPCERR 1035)
CAUSE: The APPC subsystem is unable to open the NMCONFIG.PUB.SYS
file.
ACTION: Restart the APPC subsystem. If the same message is returned,
call your HP representative.
1036 MESSAGE: UNABLE TO CLOSE NMCONFIG FILE. (APPCERR 1036)
CAUSE: The APPC subsystem is unable to close the NMCONFIG.PUB.SYS
file.
ACTION: Restart the APPC subsystem. If the problem still exists, call
your HP representative.
1037 MESSAGE: CONFIGURATION ERROR. (APPCERR 1037)
CAUSE: The APPC subsystem detected an error return code from the
NMCONF call of Node Management Services.
ACTION: Check the configuration of the APPC subsystem.
1038 MESSAGE: UNABLE TO OPEN SUBSYSTEM CATALOG FILE.
(APPCERR 1038)
CAUSE: The APPC subsystem is unable to open the catalog file
CATAPPC.APPC.SYS.
ACTION: Type LISTF CATAPPC.APPC.SYS to see if the file exists. Call
your HP representative.
1039 MESSAGE: UNABLE TO CLOSE SUBSYSTEM CATALOG FILE.
(APPCERR 1039)
CAUSE: The APPC subsystem is unable to close the catalog file
CATAPPC.APPC.SYS.
ACTION: Type LISTF CATAPPC.APPC.SYS to see if the file exists. Call
your HP representative.
1040 MESSAGE: NMLOG FILE OPEN FAILED. (APPCERR 1040)
CAUSE: The APPC subsystem is unable to open the Node Management
Log File.
ACTION: Check the logging class configuration in NMMGR.
1041 MESSAGE: NMLOG FILE CLOSE FAILED. (APPCERR 1041)
CAUSE: The APPC subsystem is unable to close the Node Management
Log File.
ACTION: Check the logging class configuration in NMMGR.