APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Appendix A 149
Messages
Logging Messages
11 MESSAGE: APPC: SNA/LINK Error, Session ID=!, Result=!
(APPCLOG 11).
CAUSE: The APPC subsystem has encountered an error in SNA/SDLC
Link/XL.
ACTION: Give the APPC subsystem internal trace to your HP
representative.
12 MESSAGE: APPC: Received Notify, Session ID=! (APPCLOG 12).
CAUSE: The remote system has sent an SNA NOTIFY command over the
session with the specified Session ID.
ACTION: This could occur (1) because of a problem with the remote
system, (2) because the remote application is not up, (3) because the LU
is not configured for use by the remote, or (4) because the Remote LU
Name specified in the configuration for the session type is incorrect. If
none of these is the case, give the APPC subsystem internal trace to
your HP representative.
13 MESSAGE: APPC: SM Detected Error, Session ID=!, Error=!, !
(APPCLOG 13).
CAUSE: The APPC subsystem has detected an internal error.
ACTION: Give the APPC subsystem internal trace to your HP
representative.
14 MESSAGE: APPC: Stray Negative Rsp, Session ID=! (APPCLOG 14).
CAUSE: The APPC subsystem has detected a stray negative response
coming from the remote system.
ACTION: No action required; however, if this occurs frequently, it may
affect the remote system. If other problems are occurring
simultaneously, notify your HP representative.
15 MESSAGE: APPC: Stray Signal, Session ID=! (APPCLOG 15).
CAUSE: The APPC subsystem has detected a stray SNA SIGNAL
command coming from the remote system.
ACTION: No action required; however, if this occurs frequently, it may
affect the remote system. If other problems are occurring
simultaneously, notify your HP representative.
16 MESSAGE: APPC: HS Detected Error, Session ID=!, Error=!
(APPCLOG 16).
CAUSE: The APPC subsystem has detected an internal error.
ACTION: Give the APPC subsystem internal trace to your HP
representative.