VISTA Plus for MPE Administrator's Guide

Chapter 2
2-10
Step 5  Enable VISTA Plus for Windows MPE
To enable VISTA Plus for Windows MPE, a flag in the VISTAINI.DATA.NETBASE file must be
set to ON. The flag is named $VISTA-PLUS-FOR-WINDOWS. A text editor must be used to
modify the VISTAINI.DATA.NETBASE file.
Note. This procedure must be performed to enable VISTA Plus for Windows MPE.
To enable VISTA Plus for Windows MPE:
1. Log on as the NetBase manager on the HP 3000.
:HELLO TED,MGR.NETBASE
2. Change to the DATA group.
:CHGROUP DATA
3. Enter a text editor and open the VISTAINI.DATA.NETBASE file:
:RUN EDITOR.PUB,SYS
>TEXT VISTAINI.DATA
4. Make sure the following line is set to ON.
VISTA-PLUS-FOR-WINDOWS ON