Using the Node Management Services (NMS) Utilities (32022-90053)

60 Chapter4
Using NMMGR Utility Screens
Output Configuration File Screen
You can select the data screens you want to list by entering one or more
selections in the print data subsystem selection fields on the Output
Configuration File screen. These are four data entry fields that allow
you to enter a number corresponding to the configurable subsystems, as
listed on the screen (see Figure 4-2).
For example, to obtain a printed listing of the configured screens for
both logging and for NETXPORT configuration, enter a 2 (for logging) in
one of the fields and a 3 (for NETXPORT) in another of the fields. If these
are the only screens you want printed, leave the other two fields blank.
When you have made your selections, press the
[Print Data] key.
If you want all screens to print, enter a 0 in one of the selection fields
(the default).
Figure 4-4 is an example of a data screen as printed by the [Print Data]
key. Because data has been entered for this screen in the configuration
file, the actual data is shown and the data flag is set to Y. If no data had
been entered, the printout would show the default values and the data
flag would be set to N.
Figure 4-4 Print Data Output Example