Using the Node Management Services (NMS) Utilities (32022-90053)

262 AppendixA
NMS Error Messages
NMGR Error and Warning Messages
MESSAGE: Extra data was specified in the command line.
(NMGRERR 552)
NMGRERR 552 CAUSE: While using the SUMMARYCONF command to obtain a DTS
critical summary report on a range of logical devices, you entered more
data than was expected in the command line.
ACTION: Reenter the command with the parameters specified in the
correct format (LDEV [xxx[/yyy]], where xxx and yyy are integers).
MESSAGE: The lower LDev # must be less than the upper LDev #.
(NMGRERR 553)
NMGRERR 553 CAUSE: While using the SUMMARYCONF command to obtain a DTS
critical summary report on a range of logical devices, the first LDEV
number you specified was higher than the second LDEV number you
specified. This is an invalid range specification.
ACTION: Reenter the command with the LDEV range specified
correctly, with the first number in the range lower than the second
number in the range.
MESSAGE: There are no LDevs within the specified range.
(NMGRERR 554)
NMGRERR 554 CAUSE: While using the SUMMARYCONF command to obtain a DTS
critical summary report on a range of logical devices, you specified a
valid range; however, there are no LDEVs within that range.
ACTION: Reenter the command with a correct range of logical devices
specified (one that includes LDEVS).
MESSAGE: The DTC Name specified is not configured.
(NMGRERR 555)
NMGRERR 555 CAUSE: You specified an incorrect DTC name while using the
SUMMARYCONF command to obtain a DTS critical summary report on a
specific DTC. Either the DTC does not exist or no data has been
configured for that DTC.
ACTION: If the name was entered incorrectly, reenter the
SUMMARYCONF command with the correct DTC name specified. If the
DTC exists but is not correctly configured, use NMMGR to configure the
data for the DTC, then reenter the SUMMARYCONF command.
MESSAGE: The Card specified is not configured in the specified DTC.
(NMGRERR 556)
NMGRERR 556 CAUSE: You specified an incorrect card number while using the
SUMMARYCONF command to obtain a DTS critical summary report on a
specific DTC. Either the DTC does not exist or the card specified is not
configured for that DTC.