Using the Node Management Services (NMS) Utilities (32022-90053)

Appendix A 239
NMS Error Messages
NMGR Error and Warning Messages
MESSAGE: This link cannot be renamed. It is used by another NI.
(NMGRERR 256)
NMGRERR 256 CAUSE: The user attempted to change the name of a link that is used
by more than one NI.
ACTION: Leave the link name as it is or reconfigure one or the other of
the NIs to use a different link.
MESSAGE: The NI name does not exist. Please specify a type to
create it. (NMGRERR 257)
NMGRERR 257 CAUSE: At the Guided HP Configuration screen, the user entered a new
NI name and pressed the Config Network key without specifying a type
in the NI type field. The type must be specified if the NI does not
already exist.
ACTION: If you are configuring a new NI, enter the type of the new NI
in the NI type field and press Config Network. If you are updating an
existing NI and entered the wrong name in the NI name field, enter the
correct NI name and press Config Network.
MESSAGE: Data saved, but profile doesn’t exist. Use GoToProfiles
command to create it. (NMGRERR 258)
NMGRERR 258 CAUSE: At the DTS Configuration screen or at one of the DTC card
configuration screens, the user specified the name of a profile that is not
configured and then pressed the save data key.
ACTION: Press the Go To Profiles key if one exists for the screen. If not,
type GoToProfiles in the command line and press Enter. This will take
you to the profile configuration screens. Configure the nonexisting
profile(s) and save the information in the configuration file. When you
are finished, press the Prior Screen key until NMMGR returns you to
the screen you were at when you originally entered the nonexisting
profile name. There is no need to re-enter the data on this screen, since
it has already been saved. Continue with the next configuration task.
MESSAGE: A DTC name must be specified. (NMGRERR 259)
NMGRERR 259 CAUSE: At the DTC Configuration screen, the user pressed the Read
DTC function key without specifying a DTC name.
ACTION: Enter a valid DTC name and try again.
MESSAGE: The DTC name does not exist; enter data and press Save
Data to create it. (NMGRERR 260)
NMGRERR 260 CAUSE: At the DTC Configuration screen, the user specified a
nonexisting DTC name and pressed either the Config Card key or the
Read DTC key.