Using the Node Management Services (NMS) Utilities (32022-90053)

Appendix A 229
NMS Error Messages
NMGR Error and Warning Messages
ACTION: Go to the validation screen and validate NETXPORT or type
exit again, this leaves the file unvalidated.
MESSAGE: DTS/LINK not validated. Type exit again to leave NMMGR.
(NMGRERR 112)
NMGRERR 112 CAUSE: Data in the DTS or LINK subsystems was changed and
DTS/LINK was not successfully validated afterwords.
ACTION: Go to the validation screen and validate DTS/LINK or type
exit again, this leaves the file unvalidated.
MESSAGE: HP-IBM not validated. Type exit again to leave NMMGR.
(NMGRERR 113)
NMGRERR 113 CAUSE: Data in the SNANODE, NRJE, or IMF subsystems was
changed and HP-IBM was not successfully validated afterwards.
ACTION: The user can go to the validation screen and validate
HP-IBM. The user can type exit again and leave the file unvalidated.
MESSAGE: Cannot find validation program NMMGRVAL.PUB.SYS.
(NMGRERR 114)
NMGRERR 114 CAUSE: File does not exist.
ACTION: Check to see what happened to the file NMMGRVAL.PUB.SYS.
If it has been inadvertently purged, try restoring it from a backup tape.
MESSAGE: Cannot send mail to validation program. (NMGRERR 115)
NMGRERR 115 CAUSE: Internal error.
ACTION: Contact your Hewlett-Packard representative.
MESSAGE: Cannot activate validation program
NMMGRVAL.PUB.SYS. (NMGRERR 116)
NMGRERR 116 CAUSE: Internal error.
ACTION: Contact your Hewlett-Packard representative.
MESSAGE: Cannot receive mail from validation program.
(NMGRERR 117)
NMGRERR 117 CAUSE: Internal error.
ACTION: Contact your Hewlett-Packard representative.
MESSAGE: LU Number “!” on page ! is a duplicate. (NMGRERR 118)
NMGRERR 118 CAUSE: The user entered two LU’s with the same LU Numbers. The
duplicate numbers may be on the same page of LU data, or one may be
on page 1 of LU data and the other on page 2 of LU data.
ACTION: Make sure all LU’s have unique numbers.