Using the Node Management Services (NMS) Utilities (32022-90053)

194 AppendixA
NMS Error Messages
NM Error Messages
ACTION: Correct this problem and retry. If necessary see “Invalid
Software Installation” at the beginning of this appendix.
CAUSE: Some of the program files and data files have the version stamp
located in the last user label record. Perhaps the file was copied without
copying its user label records properly.
ACTION: See “Invalid Software Installation” at the beginning of this
appendix.
MESSAGE: MODULE FLAGS parameter invalid. (NMERR 106).
NMERR 106 CAUSE: The MODULE FLAGS MODE field (bits 7:6) is not in the range
0 to 5, or the TYPE field (bits 13:3) is not in the range 0 to 2. Returned
by NMSUBSYSVERS, SUBSYSOVERS, and other subsystem level 2
version check procedures. Probable internal error by caller.
ACTION: See “Submitting an SR” at the beginning of this appendix.
MESSAGE: FLAGS options are incompatible. (NMERR 107)
NMERR 107 CAUSE: Some mutually incompatible option bits were set in the FLAGS
parameter. Returned by NMSUBSYSVERS, SUBSYSOVERS, and
other subsystem level 2 version check procedures.
ACTION: See “Submitting an SR” at the beginning of this appendix.
MESSAGE: Unable to create the link manager process. (NMERR 130)
NMERR 130 CAUSE: A non-zero result code was returned by NMMONSTARTREQ
to NMOPENLINK.
Returned by NMOPENLINK. Loader error trying to load
LINKMGR.PUB.SYS program file.
ACTION: Try to ALLOCATE LINKMGR.PUB.SYS. If this fails, correct the
problem according to the error messages given. If this succeeds, retry
the action that led to the problem. If this error occurs again, this is not
the problem.
CAUSE: Out of MPE resources.
ACTION: See “Insufficient MPE Resources” at the beginning of this
appendix.
CAUSE: A non-zero result code was returned by NMMONSTARTREQ
to NMOPENLINK. Returned by NMOPENLINK. Internal error.
ACTION: See “Submitting an SR” at the beginning of this appendix.
MESSAGE: Invalid item detected in configuration record.
(NMERR 131)
NMERR 131 CAUSE: Error reading and/or interpreting data from configuration file.
Returned by NMOPENLINK.
ACTION: See “Corrupt Configuration File” at the beginning of this
appendix.