Using the Node Management Services (NMS) Utilities (32022-90053)

Chapter 6 135
NMMAINT
Running NMMAINT
Running NMMAINT
To run NMMAINT, enter the command:
:RUN NMMAINT.PUB.SYS
NMMAINT responds with the following:
NMS Maintenance Utility 32099-11018v.uu.ff (C) Hewlett Packard Co. 1985
NMMAINT then lists the version identification numbers for each
software module and information for each subsystem. As shown in the
example below, the NMMAINT utility displays version information for
the subsystems of the products actually installed on your system. The
node management services, link services, and network transport
subsystems are displayed if an NS 3000/iX link product is installed.
The Network Services subsystem is displayed if the NS 3000/iX services
product is installed. The SNA Transport, SNA NRJE, RJE, SNA DHCF,
APPC, HP SNADS, SNA/X.25, NS Over SNA, HP SNADS, and SNA IMF
subsystems are displayed if the appropriate HP-to-IBM data
communications products are installed on your system.
NMMAINT Output
This example of NMMAINT output shows a system with NS 3000/iX
services and an IEEE 802.3 link installed. (The IPCVERSION module is
port software. This is not part of the NetworkIPC user service, nor does
it form a subsystem, but its individual version ID number is displayed
by NMMAINT for your information.)
Notice that version ID numbers include version, update, fix levels, and
an internal fix level in the format vuuffiii.ForNMVERS00, the version ID
number is A0103023. A is the version level, the next two digits
represent the update level, and the next two digits are the fix level. The
remaining numbers, 023, show the internal fix level, which is used only
within Hewlett-Packard.
NOTE The version numbers shown in this example are not intended to be the
same as the version numbers of your software.
Example :RUN NMMAINT.PUB.SYS
NMS Maintenance Utility 32098-20014B.00.08 (C) Hewlett Packard Co.
Subsystem version ID’s
Node Management Services 32098-20014 module versions: