UPS Utility Manual

3.9 RESTART Command
The RESTART command is a shortcut method of stopping and then restarting the UPS Monitor Process.
It is equivalent
to issuing a STOP command immediately followed by a START command.
Like
the STOP command, the RESTART command will be rejected if the UPS Monitor Process is not running at the time
the RESTART command is issued.
The first example below shows a normal,
successful execution of the RESTART command, while the second example
shows the results when the RESTART command is rejected
because the UPS Monitor Process was not running when the
RESTART command was given.
Before issuing the RESTART command, you can
use the STATUS command to verify that the UPS Monitor Process is
running.
After executing the RESTART command, you can
use the STATUS command to verify that the RESTART command
worked.
The STATUS command should reveal that the UPS Monitor Process is again running, after shutting itself down and
then relaunching itself.
Syntax
restart
Example #1
- Normal RESTART
--------------------------------------------------------------------
UPSUTIL: Command > restart
--------------------------------------------------------------------
Begin RESTART UPS Monitor operation
RESTART UPS Monitor operation successfully executed.
End RESTART UPS Monitor operation
--------------------------------------------------------------------
UPSUTIL: Command >
Page
47
of
48
UPS Utility
7/18/2008
http://jazz.external.hp.com/papers/upsutil.htm