Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

Chapter 4 79
TermDSM Commands
R[ESET] SN[P]
R[ESET] SN[P]
Resets the specific X.25 card in a specific DTC.
Security level: 2.
Syntax
SN[P] dtcnum,cardnum
Parameters
dtcnum Number of the DTC that contains the X.25 (SNP) card.
This is the number TermDSM associates with this
DTC.
cardnum Number of the interface card within the DTC. The
cards are numbered from zero beginning at the bottom
of the DTC. (Note that SNP cards may not be mounted
in slot 0 or 1 for DTC 16, and slot 0 for DTC 48.)
Description
When the subcommand is entered, the specified X.25 card is reset. All
VCs on the X.25 card are reset (up to 256 VCs for DTC 48 and DTC
72MX, and up to 32 VCs for DTC 16).
After entering the DTC subcommand, the following is printed on the
terminal:
Warning: This will abort all users on this SNP. As many
as 256 virtual circuit users could be affected. (TDSM 45)
Do you want to continue (yes/no)?
If you answer no to this question, you will be returned to the reset
prompt. If you answer yes, the reset continues.