Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

78 Chapter 4
TermDSM Commands
R[ESET] SI[C]
R[ESET] SI[C]
Resets all ports of a specific Serial Interface Card in a specific DTC.
Security level: 2.
Syntax
SI[C] dtcnum,cardnum
Parameters
dtcnum Number of the DTC to which the device is connected.
This is the number TermDSM associates with this
DTC.
cardnum Number of the interface card within the DTC to which
the device is connected. The cards are numbered from
zero beginning at the bottom of the DTC.
Description
When the subcommand is entered, all ports of the card are reset. When
the reset completes, the status of each port of the card will be displayed.
The reset prompt will then be displayed and you can enter another
RESET subcommand.
This subcommand should also be used when resets of a particular port
on an SIC have been unsuccessful. If the reset of the card is also
unsuccessful, consider using the DTC subcommand to reset the entire
DTC.