Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

Chapter 4 73
TermDSM Commands
R[ESET]
R[ESET]
To clear hardware and software associated with a logical device
number, physical port, serial interface card, or DTC so that a new
session or job can be started on each port.
Security level: 1 for DTC; 2 for remaining functions.
Syntax
R[ESET]
Description
After the RESET command is entered, the following prompt is printed
on the terminal:
(reset)
Ldev #
POrt #,#,#
SNp #,# (X.25 card in DTC)
Vc #,#,#
SIc #,# multiplexer card in DTC)
DTc #
(carriage return to exit) ?
These are the subcommands that can then be entered. The following
pages describe each of these options.
If you press [Return] instead of one of the subcommands, you will be
returned to the major prompt and may then enter another TermDSM
command.
Some port/ldev problems can not be fixed with ldev or port resets. If a
port is still unusable after a reset, consider using RESET SIC. Note that
this will affect all users on that card. Finally, if the RESET SIC is also
unsuccessful, then the entire DTC should be reset. Note that this will
affect all the users on the DTC.