Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

68 Chapter 4
TermDSM Commands
DU[MP] SN[P]
DU[MP] SN[P]
Captures data pertaining to a particular X.25 card and writes it to a
disk file.
Security level: 2.
Syntax
SN[P] dtcnum,cardnum
Parameters
dtcnum Number of the DTC that contains the SNP card (X.25
card). This is the number TermDSM associates with
this DTC.
cardnum Number of the interface card within the DTC. The
cards are numbered from zero beginning at the bottom
of the DTC. (Note that SNP cards may not be mounted
in slots 0 or 1 for DTC 16, and slot 0 for DTC 48.)
Description
Information associated with the X.25 card is dumped to a disk file.
Complete SNP RAM will be dumped to the disk file. Because of this, all
X.25 connections using the specified SNP card are aborted. The
following message is displayed:
Warning: This will reset all users on that SNP. As many
as 256 virtual circuit could be affected (TDSM 45).
Do you want to continue (yes/no)?
If you respond no, the DUMP prompt will be repeated for you to enter
another DUMP subcommand. If you respond yes, the dump continues.
When the dump is complete, the following information will be
displayed:
Please deliver the following SNP dump to your HP representative.
Cbxxxxxa.PUB.SYS
where b is the board number in that DTC, xxxxx is the last 5 characters
of the IEEE 802.3 address of that DTC and a is a character in the
sequence a, b, ...,z to allow multiple dumps.