Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

60 Chapter 4
TermDSM Commands
DT[C]
DT[C]
Lists each DTC assigned to the system and displays the number that
TermDSM has assigned to each DTC.
Security level: 2.
Syntax
DT[C]
Description
When this command is entered, information similar to the following is
displayed on the terminal:
Your system has these Datacommunications Terminal Controllers:
DTC Network Name
Number Address
----- -------- ----
1 08000900180A BIOLAB
2 080009000808 MARKETING
3 080009001234 TIMESHAREROOM
^
Use this number as the "DTC number" in TermDSM commands.
The DTC Node Name that was associated with each DTC at
configuration time is displayed along with the IEEE 802.3 station
address of each DTC. The number in the first column is assigned by
TermDSM and these numbers must be used in other TermDSM
commands to reference particular DTCs.
After the above display is printed, the major prompt will be printed and
you may enter another TermDSM command.
If, during a TermDSM command, you make an error in specifying a
DTC number, the above display is automatically printed to the terminal
for your convenience.
NOTE The listing of DTCs with an IEEE 802.3 station address and name is
not a guarantee that each DTC exists, is installed, is powered on, or is
otherwise functional. This information is obtained from the
NMCONFIG.PUB.SYS file and is therefore only a reflection of what has
been configured (correctly or otherwise).