Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

Chapter 4 59
TermDSM Commands
DI[AG] XN[ETWORK]
How many times do you want to repeat this operation?
Enter the number of times you want to run this diagnostic function.
Enter a number between 1 and 65535. The following is then printed on
the terminal:
Type CONTROL - Y to stop the looping.
You can use subsystem break (normally [CTRL]-Y to stop the diagnostic
at any time. The diagnostics prompt will be printed and you will be
allowed to enter another subcommand.
If TermDSM knows that this test has failed, an error message will be
printed listing the reason for the failure and how many milliseconds the
test ran before failing. The diagnostics prompt will be printed and you
will be allowed to enter another subcommand.